Nikko Steel Kawat Las Elektroda For Maintenance Welding ALUMIN12

Brosur & Katalog Produk / Brosur & Katalog Produk

446 views
0 Likes
0 0

Share on Social Networks

Share Link

Use permanent link to share in social media

Share with a friend

Please login to send this document by email!

Embed in your website

Select page to start with

1. MANUFACTURERS OF A DIVERSE RANGE OF ADVANCED WELDING CONSUMABLES SECTION 10 ALUMIN 12 BASIC FLUX COATED ALUMINIUM-12 SILICON ELECTRODE FOR WELDING NON HEAT-TREATABLE ALUMINIUM ALLOYS CONTAINING UP TO 12% Si DATA SHEET NO. 150 SPECIFICATION DIN 1732 CLASSIFICATION EL-AISi12 PRODUCT DESCRIPTION Manufactured using a fully alloyed core wire, the chemically basic flux which contains a high proportion of chlorides and fluorides using a silicate with a high molecular ratio of silica to sodium oxide. The flux, as well as providing a shielding gas, also produces a slag with a vigorous cleaning action. WELDING FEATURES OF THE ELECTRODE The electrode is suitable for use on DC+ only. Aluminium has a low melting point, therefore the electrode burn-off rate is considerably higher than all other electrodes, thus necessitating high travel speeds. As the alloy is non-heat-treatable, it will only match the properties of cast alloys. APPLICATIONS AND MATERIALS TO BE WELDED May be used for rectification of casting defects, particularly those present at the surface. Also for welding cast aluminium components which have become worn or damaged in service. May also be used for cosmetic repairs on similarly alloyed wrought components. The aluminium association designations for 12% Si aluminium includes 13, A13, B13 and 3S4. WELD METAL ANALYSIS COMPOSITION % BY Wt. Mg Mn Si Fe Cu Zn Ti Al Other Impurities MIN - - 11.0 0.5 0.05 0.10 - - MAX 0.05 0.3 13.5 - - - 0.15 0.15 TYPICAL 0.04 0.04 12 0.8 0.23 0.08 0.1 Bal. WELD METAL PROPERTIES (ALL WELD METAL) PROPERTY UNITS MINIMUM TYPICAL OTHERS Tensile strength N/mm 2 - 170 0.2% Proof stress N/mm 2 - - Elongation on 4d % 5 9 - Reduction of Area (RA) % - - WELDING AMPERAGE DC+ ∅ (mm) 3.2 MIN 70 MAX 130 OTHER DATA Electrodes that have become damp should be re-dried at 60 o C for 30 minutes. RELATED PRODUCTS Please contact our Technical Department for detail. WI-0304 DS150 ALUMIN 12, Rev. 0, Date 01.09.2008

Dilihat

  • 446 Total Views
  • 250 Website Views
  • 196 Embedded Views

Tindakan

  • 0 Social Shares
  • 0 Likes
  • 0 Dislikes
  • 0 Comments

Share count

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Embeds 6

  • 35 sentral.indoteknik.com
  • 35 indoteknikcom.odoo.com
  • 3 indoteknik.co.id
  • 3 indoteknik.com
  • 2 depoperkakas.com
  • 1 ezmaro.com